E-On Energy Fit Starter Pack Guide de l'utilisateur télécharger pdf (Page 31)

Problem

No display

Faulty display and/or display

power supply

pressing option 1.

Possible cause Solution

Corrupted display

(incomplete data)

Faulty display

pressing option 1.

Alternating readings

Display picking up a signal from

a neighbours’ transmitter

Tune your transmitter and

display again, see page 11

Data does not change Incorrect installation Review pages 9-13

Costs reading seems

excessively high or low

Correct tariff has not been set Refer to page 15

Temperature gauge

excessively high

Display too close to heat source Choose a different location

Don't attempt to repair any part of your Energy Fit Starter Pack yourself. If there are any problems

and the above suggestions haven't worked, give one of our team a call on 0800 092 9106, and press

option 1. Our advisers are on hand Monday to Friday, 11am to 7pm, Saturdays 9am to 5pm.

Display is showing '0 watts'

The sensor jaw may be around

more than one cable.

Check which cable the sensor

jaw is around. Make sure it is

around just the 'live' cable - see

page 12.

Troubleshooting

Display shows dashes (---)

instead of 'watts' occasionally.

Temporary loss of signal

It should reconnect in a matter

of seconds but make sure the

monitor is within 30 metres of

your electricity meter.

Energy Manager Booklet Customer_Layout 1 27/05/2010 14:55 Page 1

1 2 ... 26 27 28 29 30 31 32 33

Pas de commentaire

E-On Energy Fit Starter Pack Guide de l'utilisateur Page 31